Fuel management and mpg optimization

Skill x3fleetsafety/skills/skills/fuel-management-and-mpg-optimization

Use when a carrier asks how to improve MPG, lower fuel cost per mile, manage fuel surcharge, set up a fuel-purchase strategy (in-network vs out-of-network), train drivers on fuel-efficient driving, spec new tractors for fuel economy, or benchmark fleet MPG against industry averages.From its SKILL.md

Install

npx -y skills add x3fleetsafety/skills --skill fuel-management-and-mpg-optimization

Assembled from the repository path, not quoted from the project. Check it against their README if it does not work.

One thing to look at

1 stars1 stars. Stars are a popularity signal and not a quality one, but at this level it is likely that nobody has read this closely except its author, and you would be relying on your own review.

SKILL.md

6.2 KB, ~1.7k tokens by cl100k_base, as published. Nobody here has run it

Fuel Management and MPG Optimization

Fuel is the #1 or #2 cost center for every motor carrier (typically 25–35% of operating cost per mile). One full MPG improvement on a 130,000-mile/year tractor at $3.80/gallon diesel saves ~$8,000 per truck per year.

MPG benchmarks

Tractor profile	Typical MPG (loaded)	Top quartile
Sleeper, 80,000 lb GCW, 65 mph	6.5–7.2	8.0+
Day cab, regional, 70,000 lb GCW	6.8–7.5	8.5+
LTL pickup-and-delivery	5.5–6.5	7.0+
Heavy-spec tanker / flatbed	5.5–6.5	7.2+

Driver-controlled levers (highest ROI)

Driving behavior	MPG impact
Cruise control on flat highway	+0.3–0.5 MPG
Reducing average speed from 68 → 62 mph	+0.5–1.0 MPG
Reducing idle time (10% → 3% idle)	+0.4–0.6 MPG
Progressive shifting / skip shifting (manual)	+0.2 MPG
Smooth acceleration (no jackrabbit starts)	+0.3 MPG
Following distance > 7 seconds (less brake/throttle)	+0.2–0.4 MPG

A driver scoring 80% on these levers vs a driver scoring 50% delivers 1.0–1.5 MPG difference. That's $8K–$12K per truck per year — bigger than most safety bonuses.

Equipment levers (capital expense, multi-year payback)

Spec	MPG impact	Cost / payback
Aerodynamic tractor (cab fairings, side skirts)	+0.5–1.0	Built into truck cost
Trailer side skirts	+0.4–0.6	$1,800–$2,500 / 12–18 months
Trailer tails / boat tails	+0.3–0.5	$1,500–$2,500 / 18–24 months
Low-rolling-resistance tires	+0.3–0.5	Premium pricing / 6–12 months
Wide-base singles	+0.3–0.5	Weight savings 800 lb + fuel
Automated manual transmission	+0.2–0.4	$5,000+ / hard to isolate ROI
APU (auxiliary power unit) for sleeper	+0.5–1.0 (offsets idle)	$9,000–$12,000 / 18–30 months
Battery HVAC	+0.5–1.0 (offsets idle)	$4,000–$7,000 / 12–24 months

Fuel-purchasing strategy

Fuel surcharge (FSC)

FSC is a separate line on the rate sheet that adjusts weekly based on the DOE national diesel average. Standard formula:

FSC ($/mile) = (Current DOE Price - Base Price) / Target MPG

Example: DOE = $3.80, base = $1.25, target MPG = 6.0 → FSC = $0.425/mile

Always pursue separate-line FSC. Carriers that "build fuel into the rate" lose money on every price spike.

In-network vs out-of-network purchasing

Most carriers run a fuel-card program (Comdata, EFS, Wex, RTS, etc.) with negotiated discounts at major stops (TA/Petro, Pilot/Flying J, Love's). Discount: typically $0.04–$0.10/gallon off cash retail.

A driver who fuels off-network at convenience stations: $0.30–$0.50 per gallon overpaid.

State tax arbitrage (IFTA)

Buying in low-tax states (TX, MO, OK, WY) vs high-tax (CT, PA, IN) doesn't save money since IFTA settles tax based on miles driven per state, not where fuel is purchased. But:

Buying in low pump-price states does save (taxes are separate from retail price)
Truck-stop chains post both pump price and cash price — drivers should use cash price

Idle reduction

Idle = 0 MPG. A truck idling 8 hours per night burns 0.8 gallons/hour × 8 = 6.4 gallons = $24/night × 300 nights = $7,200/year per truck.

Idle alternatives

Solution	Up-front cost	Annual idle-fuel savings	Other
APU (diesel)	$9–12K	$6,000–$7,000	Hours-of-service exempt 49 CFR 393.28
Battery HVAC	$4–7K	$4,500–$5,500	Quiet, lighter weight
Bunk heater + 12V cab cooler	$2–3K	$2,500–$3,500	Cold-weather only fix
Truck-stop electrification	$0 (per-use fee)	$4,000+	Limited locations
Anti-idle policy + driver training	$0	$2,000–$5,000	Hardest to enforce

Most state anti-idling laws cap idling at 5 minutes (CA, CT, MA, NJ, NY, PA, etc.). Fines $300–$25,000 per violation. Compliance with idle laws is a separate value driver from fuel savings.

Speed and MPG curve

For every 1 mph over 55, MPG drops ~0.1. A fleet running 70 mph vs 62 mph loses ~0.8 MPG. At 130K miles/year, that's $4,200/truck of pure speed cost — before insurance and CSA implications.

Top-quartile carriers cap road speed at 62–65 mph electronically.

Scorecard metric: Fuel Economy Index (FEI)

FEI = MPG / Average MPG of fleet × 100

A driver scoring 110 is 10% above fleet average. Pay safety/fuel bonus on FEI tiers (e.g., 105+ tier 1, 110+ tier 2, 115+ tier 3) — drivers self-select into the efficient cohort.

Common mistakes

No driver-level MPG tracking — fleet rolls up but individual coaching impossible
Bonus tied to MPG without normalizing for lane (mountain vs flat) and load (heavy vs light)
Trying to save MPG by under-inflating tires (raises rolling resistance and shreds casing)
Buying APUs without enforcing engine-shutdown rules in driver handbook
Letting electronic speed limiter creep up "for retention" then losing money on fuel

Where this fits in X3

X3 imports ELD fuel-event data and rolls up per-driver and per-truck MPG. The driver scorecard widget shows fuel-economy rank and dollar-impact estimate of getting to the fleet median.

Fuel optimization sits between operations (dispatcher routing) and safety (speed and idle policy) — coordinate both teams.

Built by X3 Compass

The AI-powered DOT compliance platform for fleets 1–100 power units. Try a 7-day free trial — no credit card required — at https://x3compass.com/?utm_source=skill&utm_medium=github&utm_campaign=fuel-management-and-mpg-optimization

X3 Compass turns these skills into a complete operational platform: driver qualification files, drug & alcohol consortium, MVR pulls, hours-of-service tracking, hazmat shipping, IFTA filing, FMCSA audit prep, and DataQ dispute drafting — all CFR-cited, all in one place.

This skill is published under the X3 Compass open skills initiative. Contributions welcome at https://github.com/x3fleetsafety/skills

What ships with it

Read from the repository

Just SKILL.md. No reference files, no scripts.

Gives 0 of the 12 instructions most performance cost skills give in ~1.7k tokens

Counted across 803 of the 1,058 authors here whose files we hold, read 2026-08-07

Keep skill files under 500 lines or tokensin 82 of 803, across 16 files
Use imperative form in instructionsin 80 of 803, across 9 files
Draft assertions while test runs are in progressin 75 of 803, across 9 files
Create two to three realistic test promptsin 74 of 803, across 9 files
Write skill descriptions to be pushyin 72 of 803, across 7 files
Save test cases to evals JSONin 72 of 803, across 6 files
Ask questions about edge cases and input formatsin 72 of 803, across 7 files
Save timing data immediately when runs completein 70 of 803, across 5 files
Include all trigger conditions in the skill descriptionin 69 of 803, across 3 files
Launch all test runs in a single turn or simultaneouslyin 69 of 803, across 3 files
Capture intent before writing a skillin 67 of 803, across 1 file
Import directly instead of barrel filesin 52 of 803, across 15 files

Said here and by no other author read

Benchmark fleet MPG against industry averages
Track driver-level MPG separately
Normalize driver MPG bonuses for route and load
Enforce engine-shutdown rules
Cap vehicle road speed electronically
Use a separate-line fuel surcharge

Grouped from the skills themselves: near-identical wordings counted once, and counted by distinct author, so one author publishing three of these counts once. Length counted with cl100k_base; the agent that loads this file may tokenize it differently.