Setup
Set up claude-cast by installing all required dependencies (mpv, streamlink, tmux) and verifying the installation.From its SKILL.md
npx -y skills add kvreem/claude-cast --skill setupAssembled from the repository path, not quoted from the project. Check it against their README if it does not work.
One thing to look at
- 7 stars7 stars. Stars are a popularity signal and not a quality one, but at this level it is likely that nobody has read this closely except its author, and you would be relying on your own review.
SKILL.md
1.5 KB, as published. Nobody here has run it
/claude-cast:setup — Install Dependencies
Set up claude-cast by installing all required dependencies.
Arguments: $ARGUMENTS
Steps
1. Check what's already installed
Run each check:
command -v mpv && mpv --version | head -1 || echo "MISSING: mpv"
command -v streamlink && streamlink --version || echo "MISSING: streamlink"
command -v tmux && tmux -V || echo "MISSING: tmux"
command -v bun && bun --version || echo "MISSING: bun"
2. Install missing dependencies
For each missing dependency on macOS:
# If mpv is missing:
brew install mpv
# If streamlink is missing:
brew install streamlink
# If tmux is missing:
brew install tmux
For Linux:
# Debian/Ubuntu
sudo apt install mpv streamlink tmux
# Fedora
sudo dnf install mpv streamlink tmux
3. Verify installation
After installing, run all checks again to confirm everything works:
mpv --version | head -1
streamlink --version
tmux -V
4. Confirm success
If all dependencies are installed, tell the user:
"claude-cast is ready. Start a tmux session and launch Claude Code:
tmux new-session -s dev
claude
Then stream:
/claude-cast shroud
"
If $ARGUMENTS is "check"
Only run the checks in step 1 without installing anything. Report what's installed and what's missing.